|
Dataliner offers two different kinds of Universal Laser Measuring Systems.
Dataliner Fan Laser Combimeter +
The dataliner Fan Laser Combimeter + Measuring system consists of a universal Cross-Alignment Scale, Telescopic Tram Gauge and a Fan Laser. It is attached to the by Hole Adapters fitting holes from 5 to 35mm. The Fan Laser is magnetic and will attach to the Cross Alignment Scale. The Tram can do length, cross and width measurements. By using the laser fan directly on magnetic targets, measuring pointers or measuring tape comparable measurements can be taken. The Combimeter + can be used with all available data charts such as Dataliner Galaxy, Mitchell, Chief, CCC Car-O-Liner, and more. Measurements can be observed during the pulling of the vehicle.
It is very easy to operate and every technician will be able to understand it and use it without any training. The Cross Alignment Scale is extremely fast and simple to attach using two Hole Adapters.
Combimeter + is a compliment measuring tool to a high-end computerized measuring system when a print out is not needed. Measurement can be observed during the pulling process.
Combimeter + comes complete with Carrying Case 3.5” x 9” x 76”. Weight 24 lb
Dataliner Line Laser Measuring System
... A Laser Aided Square Angel
The Dataliner Line Laser Measuring System consists of a length and a width measuring rail positioning around the vehicle like a square angle. It uses a Line Laser which projects the beam through an “Automaster” or beam splitter. Targets are hung under the chassis on bolts or in holes according to a Dataliner Data Chart printed out from a Galaxy CD-ROM. Length, width and height can be measured. The Beam Splitter can be used for upper body measurements. The McPherson Gauge will check the suspension struts.
The Dataliner Line Laser Measuring System is a high-end accurate measuring system. It is technician friendly with continuous verification while the vehicle is being pulled. The Galaxy Software enables you to print out Factory Specification, Damage Report and After Repair Report.
|
Speed
With the Dataliner Laser Measuring System, a car can be measured on its wheels while using only two attachments to the car. Since the measuring system can be left in place, setup time is minimal.
Simplicity
The laser beam can be easily directed to any upper body or suspension location for comparison measurements
|
|
|
|
|
|
Flexibility
With our unique beam splitter, control points can be measured without having any attachments on the vehicle. Suspension points and wheel angles can be quickly and easily measured for any deviations or misalignments.
Mobility
Our laser measuring system can easily be moved from one vehicle to another. Your vehicles can even be measured on their wheels, while on the floor.
|
|
|
Suspension Points
Any suspension point can easily be measured for height, length and width.
|
|
|
|
|
|
Wheel Angles
Wheel positions and wheel angles can easily be measured with the laser beam.
|
|
|
Continuous Verification
Your technician can readily observe measurement changes while the vehicle is being pulled.
|
|
|
|
>> Click here to see Combimeter + Application Examples <<
>> Click here to see Measuring System Accessories <<
|
